MM2X Forum

I actually took a request for this car! Silent1Unknown was the one I chose, because the Dodge Avenger is a pretty cool looking car!

I don't have an actual 3D Model at this time, but I'm practicing with some poly placement - with that said, here is the beginning:



I should get a job designing cars in 2D

Some wireframe progress:



Now it's time to reveal the car I'm tracing before it gets too confusing to tell wtf is going on:



Even more progress!



Fixed the grille a bit and fixed some disproportional stuff:

nice looking car bro here is the dash pic:
https://www.seriouswheels.com/pics-2007/ ... 80x960.jpg

Thanks Sido!

Wow, thanks for taking my request. I'm very curious to see how you model this without blueprints. Good luck!

wires are wrong

That's some great modeling.

Nice start. With no prints, I would start with a spline cage. Make your wires more even throughout the car! See pic:

Nice tracing

I was just doing this for practice, and I haven't had time to do any work guys - there's someone else in my life now

Hey guys, I'm going to be putting this project on hold because I still don't feel as if I have enough experience to be modeling these kind of cars...please understand that I've been trying to practice really hard lately, and that the Dodge Avenger is too hard to attempt with the knowledge I have right now.

It's fine, atleas you're trying-unlike me ahaha

check his wires:

https://www.3dexport.com/img-dodge-aveng ... htm#topimg

I found a nice avenger blueprint here:
https://car-blueprint.com/car-blueprint/ ... 0046755951

Have fun.