New car! 2008 VW Scirocco..zm pics. im trying to make it a hipoly car.
New car! 2008 VW Scirocco
2008 VW Scirocco WIP
- Franch88
- MM2X Admin
- Posts: 15759
- Registered for: 16 years 11 months
- Location: Italy
- Been thanked: 1 time
- Contact:
Looks very good so far, very good polygons placement and shapes, great work with your first high polygons car modeling.
Fiat 500 = Italian motorization. Franch88, MM2 eXtreme forum and website Administrator.
|Franch88's MM2 Releases|
|Franch88's MM2 Releases|
- Franch88
- MM2X Admin
- Posts: 15759
- Registered for: 16 years 11 months
- Location: Italy
- Been thanked: 1 time
- Contact:
Nice progress, good work.
Fiat 500 = Italian motorization. Franch88, MM2 eXtreme forum and website Administrator.
|Franch88's MM2 Releases|
|Franch88's MM2 Releases|
- Franch88
- MM2X Admin
- Posts: 15759
- Registered for: 16 years 11 months
- Location: Italy
- Been thanked: 1 time
- Contact:
Maybe he uses blueprints, but he hasn't never told that. That problem with the blueprints that comes up while modeling is given because the blueprint is badly made with lines and proportions that aren't equal between the views. This is exaplained in the Silent1Unknown's tutorial here. Is hard fix it, you have to continue with modeling paying attention to fix the model aspect as best as possible.
Fiat 500 = Italian motorization. Franch88, MM2 eXtreme forum and website Administrator.
|Franch88's MM2 Releases|
|Franch88's MM2 Releases|
@ DMX : This problem happens most of the time because perfect blueprints are rare. You can try to fix only the bad views (in this case, the front one by moving it with the backg. img control).
BTW I don't really see any problem from your pic to be honest. Polys from the top view are well placed too from the front view.
However, there's a mistake about the hood placement. If you want to improve your mesh, fix the edges on this way.
Keep in mind, each edge must be attached to another one. Don't let an edge alone
BTW I don't really see any problem from your pic to be honest. Polys from the top view are well placed too from the front view.
However, there's a mistake about the hood placement. If you want to improve your mesh, fix the edges on this way.
Keep in mind, each edge must be attached to another one. Don't let an edge alone